Table of Contents
Advertisement
Inputs for Sensors
Configuration Using View Software
Technical Notes
Document 800-07766V1 Rev A
02/11
1.
Using View, start a Maintenance session for the Rapid Eye site. Wait until the System
Operational message appears. Click the Events tab. More tabs are displayed.
2.
Click the Inputs tab.
3.
Enter the name of an input in its Input box. You have the option of identifying inputs
that are not in use, such as input 7 and input 8 (see
4.
You have the option of monitoring the activation of inputs and their deactivation by
selecting Log and Alarm, as needed.
5.
By default, alarm/control inputs are configured as NO (normally open). Click NC
(normally closed) or EOL (end-of-line), as needed.
Figure 5-4
Input Configuration During a Maintenance Session
Inputs to a Multi-Media LT DVR Used by Hardware Devices
Honeywell recommends that installers report the connection of input devices to the
organization Multi-Media System Administrator, indicating if the devices are using
connections that are: normally open, normally closed or end-of-line.
Rapid Eye™ LT DVR Installation Guide
Figure
5-4).
55
Advertisement
Table of Contents
