Powering The Multi-Media Dvr; Configuring The Multi-Media Dvr; Next Steps; Operating The Dvr Remotely - Honeywell Rapid Eye Installation Manual

Multi-media digital video recorder

Hide thumbs Also See for Rapid Eye:

Table of Contents

Powering the Multi-Media DVR

Document 800-02607V3 Rev A

11/09

Honeywell recommends that you apply power to the Multi-Media DVR through an

uninterruptible power supply (UPS). For more information, see

Caution

In Europe, a UPS is required to meet EN50130-4 Euro Norm.

Whether you plan to operate the DVR onsite (using LocalView) or remotely (using View

software via a network connection), you need to set up LocalView.

Note

For remote operations using only dial-up, you do not need to set up

LocalView.

The following chapters in this guide provide detailed procedures and reference materials,

starting with

Chapter 2,

Installation.

If you plan to perform a quick connection after the installation, to connect remotely to Rapid

Eye DVRs, you should refer to the

Administrator

Guide, and the

Common Operator

Guide, for the necessary procedures.

Rapid Eye™ Multi-Media DVR Installation Guide

Rapid Eye™ Multi-Media Digital Video Recorder System

Powering Up

on page 29.

Table of Contents