Table of Contents
Advertisement
Site Hardware
Driver (name)
Kalatel
Pelco D
Pelco P
Rapid Dome/Orbiter
SensorMatic RS422
Ultrak (using VCL)
Ultrak KD6
a
The drivers are not listed alphabetically in the View application. A driver can be used with
domes other than those listed. For other domes, controllers, or PIT devices, refer to the docu-
mentation provided with the device.
Alarm Sensors
Connecting an Alarm Sensor
54
Table 5-3
PTZ Drivers for Controllers and Domes (cont'd)
a
Baud rate
9600 or 2400
4800, 9600, or 2400 Pelco D
2400
9600
4800
2400
9600
Caution
After the installation, installers should communicate to the Multi SA: each
address used by the PTZ domes and the number of the port used for PTZ
on the Rapid Eye LT DVR.
To connect alarm-type hardware to a Multi-Media LT DVR, use hookup wire in the 20-gauge
range.
Tools you may need:
•
A slot screwdriver (supplied). The screws are smaller than those for a 1/8 inch
screwdriver.
•
A wire stripper.
1.
From the alarm wire tips, strip approximately 0.6 cm (1/4 inch) of insulation.
2.
Insert each alarm wire into the screw-type, terminal connector on the ALARM terminal
strip: one wire to the numbered terminal connection and the other wire to ground.
Caution
To avoid short-circuits, ensure that bare wire is not visible at the rear panel.
Support for (dome/controller/PIT device)
Kalatel KTD312 Cyberdome
Pelco P
RapidDome or Orbiter
SensorMatic RS422: Delta and Speed
Ultrak (configured as VCL)
KD6, HD6, HD6i
Advertisement
Table of Contents
