Testing A Network Connection In The Field; Dial-Up Connection; Figure 2-9 Localview Panel For Network Settings; Figure 2-10 Telco Port For Dial-Up Connection (North American Units Only) - Honeywell Rapid Eye LT Installation Manual

SPOT
MONITOR
1
VIDEO
INPUTS
SERIAL PORT 2
SERIAL PORT 1

Testing a Network Connection in the Field

Dial-up Connection

Telco port
Document 800-07766V1 Rev A
02/11
Figure 2-9 LocalView Panel for Network Settings
COMMON CONTROL
SYS FAIL
OUTPUTS
SYS GOOD
1 G 2 G 3
FAULT
RELAY
2 3 4 5 6 7 8
28V, 3A
MAX
1 G G 2 3 G 4 G 5 G G 6
ALARM INPUTS
TELCO
LAN
IN
OUT
115-230V~
VGA
50/60 Hz
NOT 5-3A
USED
USB USB
To test a network connection, PING the DVR.
The internal modem is only supplied with North American Rapid Eye LT units. European
units requiring modem functionality require an external modem connected to Serial Port 1
or 2 (see the documentation that came with the external modem for connection
information). The following instructions describe using the internal modem with North
American units.
Figure 2-10 TELCO Port for Dial-up Connection (North American Units Only)
TELCO
LAN
USB
1. Using a standard telephone cable with RJ11 connectors, plug one connector into the
TELCO port on the DVR (see
Rapid Eye™ LT DVR Installation Guide
SERIAL
G 4 G
PORT 3
SERIAL
PORT 4
7 G 8 G
ON/OFF
POWER
SPOT
MONITOR
1 2 3 4 5
VIDEO
INPUTS
TELCO
SERIAL PORT 2
SERIAL PORT 1 VGA
USB
Figure 2-10).
164.178.32.1
COMMON CONTROL
SYS FAIL
OUTPUTS
SYS GOOD
1 G G 2 3 G 4 G
FAULT
RELAY
6 7 8 28V, 3A
M AX
5 G 6 G 7 G 8 G
1 G 2 G 3 G 4 G
ALARM INPUTS
LAN
IN
OUT
115-230V~
50/60 Hz
NOT
5-3A
USED
USB
SERIAL
PORT 3
SERIAL
PORT 4
ON/OFF
POWER
35