System Monitoring; Connection To An Alarm Panel; Fault Relay Hardware; Figure 5-5 Connecting The Dvr Fault Relay To An External Alarm Panel - Honeywell Rapid Eye LT Installation Manual

System Monitoring

Connection to an Alarm Panel

Fault Relay Hardware

Document 800-07766V1 Rev A
02/11
Purpose
Outputs can be activated by:
• A View operator
• Automatically, by response rules, set by a System Administrator (see
Monitoring).
A Multi-Media LT DVR can be monitored for failure to:
• Function
• Report alarms
• Hardware failure to record video
• Configuration error, to stop the recording of video.
Connect a combination of Fault Relay circuitry and outputs to an alarm panel, preset to
warn your organization if a failure occurs. An output can be configured to respond to a
Response Schedule.
Figure 5-5 Connecting the DVR FAULT RELAY to an External Alarm Panel
INPUT to external
alarm panel
SPOT
MONITOR
1 2 3 4
VIDEO
INPUTS
SERIAL PORT 2
SERIAL PORT 1 VGA
Rapid Eye™ LT DVR Installation Guide
Not
COMMON
SYS FAIL
used
SYS GOOD
FAULT
RELAY
28V, 3A
MAX
COM MON
SYS FA IL
SYS GOOD
FAULT
RELAY
5 6 7 8 28V, 3A
MAX
1 G 2 G 3
ALARM
TELCO
LAN
IN
OUT
115-230V~
50/60 Hz
NOT
5-3A
USED
USB USB
System
CONTROL
OUTPUTS SERIAL
1 G 2 G 3 G 4 G
PORT 3
SERIAL
PORT 4
G 4 G 5 G 6 G 7 G 8 G
INPUTS
ON/OFF
POWER
57