Dip Switch Sw2 Settings - Sekonic SR-1800 Operating Manual

DIP Switch SW2 Settings
4
CAUTION
· Be careful when configuring settings. Marks will be misread if the settings are incorrect.
· Make sure the power is off when configuring settings.
: Indicates the factory settings.
Contents of setting
No. of lines
Control type
12 lines Direct-under type
Mark-to-mark type
Control type
24 lines Direct-under type
Mark-to-mark type
Control type
32 lines Direct-under type
Mark-to-mark type
Control type
38 lines
Direct-under type
Control type
40 lines Mark-to-mark type
Direct-under type
48 lines Direct-under type
Automatic sheet discharge
Sheet empty detection
Timing mark error detection
(Not used)
SW2-1 to 4: Select the number of lines to read and the timing mark type according
to the sheet used. Mark-to-mark type is set for "Without top-end margin
reading."(Reference: "OMR Glossary" (P.45) - Timing control type, Direct under
type, Mark to mark type)
Priority is given to the settings from the computer side.
Timing type 1
ON
OFF
OFF
OFF
ON
ON
OFF
ON
OFF
OFF
ON
OFF
ON
ON
ON
ON
OFF
ON
OFF
ON
OFF
-
-
OFF OFF
NO. NO.
ON ON
SW2
2 3 4 5
ON ON OFF
OFF OFF ON
OFF ON ON
OFF ON OFF
OFF ON OFF
ON OFF OFF
ON OFF OFF
ON OFF ON
ON OFF ON
ON ON ON
ON ON ON
OFF OFF OFF
OFF OFF OFF
OFF OFF ON
OFF ON ON
ON
OFF
SR-1800
6 7 8
ON
OFF
ON
OFF
ON
OFF