Clamps; Mounting Procedure - High End Systems Cyberlight 2.0 User Manual

Clamps

You must supply two clamps and verify they are capable of supporting the weight of the fixture
with the yoke (45kg (99 lb)). You can order truss clamps from your High End Systems dealer/
distributor (see Related Products and Accessories on page 5).
Make sure the fixture cannot be rotated all the way around (360°). (Using two clamps is a good
way to do this). Allowing the fixture to rotate 360° could loosen the clamp mounting bolts.

Mounting Procedure

Because of the variety of conceivable lighting designs, you should consider the procedure below
as a suggested guideline only. High End Systems cannot make specific recommendations for
your particular lighting design or venue.
CAUTION:
Always stand on a firm, stable surface and use three people to
mount each Cyberlight 2.0 fixture; two people to hold the fixture
while it is being secured in place, and one person to secure the
fixture to its support and to attach clamps and safety cables.
Only experienced lighting personnel should attempt to hang a lighting
fixture to an appropriate theatrical truss.
To mount the fixture:
1. Attach two clamps using the holes on the yoke. Use locking washers when attaching the
clamp to the yoke
2. Tighten the clamps firmly to the Cyberlight yoke and to the support.
3. Loop one or more suitable safety cables around the support and around the Cyberlight
yoke.
CAUTION:
Do not use the fixture handles as a safety cable attachment
point. The Cyberlight handles are intended only for hand-
lifting the fixture.
WARNING:
Failure to use a safety cable could result in injury or death. High End
Systems supplies the proper safety cables and may be contacted for
replacements if necessary. For more information go to:
www.highend.com/trusshang.
Cyberlight 2.0 User Manual
®
CHAPTER 2
Installation and Setup
11