Honeywell HX2 Reference Manual page 241

Parameter Default
Specify 802.11a, 802.11b and/or 802.11g rates when communicating with the AP. The options dis-
played for this parameter depend on the type of radio (802.11b/g or 802.11a/b/g)installed in the mobile
device.
Options:
BG radio:
BG Rates
Full
BG radio only – Previous SCU versions may have the default set as BG Rates Full. Depending on
Or
Radio the SCU version, either BG Optimized or BG subset is the default.
A radio:
Mode
For example, if this parameter is set to G rates only, the HX2 may only connect to APs set for G
BGA
rates and not those set for B and G rates.
Rates
The options for the Radio Mode parameter should be set, based on the antenna configuration, as fol-
Full
lows:
Contact
B rates only (1, 2, 5.5 and 11 Mbps)
BG Rates Full (All B and G rates)
G rates only (6, 9, 12, 18, 24, 36, 48 and 54 Mbps)
BG optimized or BG subset (1, 2, 5.5, 6, 11, 24, 36 and 54 Mbps)
A rates only (6, 9, 12, 18, 24, 36, 48 and 54 Mbps)
ABG Rates Full (All A rates and all B and G rates with A rates preferred)
BGA Rates Full (All B and G rates and all A rates with B and G rates preferred)
Ad Hoc (when connecting to another client device instead of an AP)
Default:
BG Rates Full (for 802.11b/g radios)
BGA Rates Full (for 802.11a/b/g radio)
It is important the Radio Mode parameter correspond to the AP to which the device is to connect.
Technical Assistance
Explanation
if you have questions about the antenna(s) installed on your HX2.
6-11