Application Panel - Honeywell HX2 Reference Manual

Application Panel

Note: Users of Single-Application AppLock have a Control tab instead of an Application tab. Some of the options in this
section do not apply to the Control tab.
Note: If your Application Panel does not look like the figure shown above, you may have the Single Application version.
Use the Application tab options to select the applications to launch when the device boots up in End-user Mode.
If no application is specified when the Administrator Control Panel is closed, the mobile device reboots into Administrator
mode. If a password has been set, but an application has not been specified, the user will be prompted for the password before
entering administration mode. The password prompt remains on the display until a valid password is entered.
Option Explanation
Default is blank. Move the cursor to the Filename text box and either type the application path or tap the Browse
Filename button (the ... button). The standard Windows CE Browse dialog is displayed. After selecting the application
from the Browse dialog, tap OK.
Default is blank. Enter the Title to be associated with the application. The assumption is that multiple copies of
Title
the same application may need unique titles in order to differentiate them in the Switchpad.
Arguments Default is blank. Enter the command line parameters for the application in the Arguments text box.
Default is 1. Enter the Order in which the application is to be loaded or presented to the end-user. Applications
Order
are launched in lowest to highest number order and do not need to be sequential.
Default is Disabled. Enable the Internet checkbox to use the End-user Internet Explorer (EUIE.EXE) When the
Internet checkbox is enabled, the Internet Menu and Internet Status are available. See the section titled End-user Internet
Explorer (EUIE) for more details.
See following section titled
Launch
Note: AppLock Administrator Control panel file Launch option does not inter-relate with similarly-named
Button
options contained in other Control Panels.
Default is Ctrl+Spc. Select the Global Key key sequence the end-user is to press when switching between
Global Key applications. The Global Key default key sequence must be defined by the AppLock Administrator. The Global
key is presented to the end-user as the Activation key.
Default is 10 seconds. Enter the number of seconds that Applications must wait before starting to run after
Global
reboot.
Delay
Note: Delay (Global) may not be available in all versions of AppLock. You can simulate a Global Delay
4-44
Launch Button.