Honeywell HX2 Reference Manual page 102

Message
Registry read failure
Reset system work area
failure
Shift pressed
Shift
Show taskbar
Switching to admin-
backdoor
Switching to admin-
hotkey press
Switching to admin-
kbdhook.dll not found
Switching to admin-
keyboard hook
initialization failure
Switching to admin-
registry read failure
Switching to
TaskbarScreenMode
Switching to user mode
Switching to user-hotkey
press
Taskbar hook failure
Taskbar hook OK
Timeout looking for app
window
ToUser after admin, not
at boot
ToUser after admin-app
still open
ToUser after admin-no
app or cmd line change
Unable to move desktop
4-60
Explanation and/or corrective action
The registry read failed. The registry information read when this message is logged is the
application information. It the Administration key cannot be opened or if the AppName
value is missing or empty, this error is logged. The other application information is not
required. If the AppName value is not available, AppLock cannot switch into user mode.
The system work area is adjusted when in user mode to cover the taskbar area. The
system work area has to be adjusted to exclude the taskbar area in administration mode.
AppLock was unable to adjust this area.
The Shift key has been pressed and trapped by the HotKey processing.
Processing the hotkey and backdoor entry
The taskbar is now being made visible and enabled.
The system is currently in user mode and is now switching to admin mode. The switch
occurred because of the backdoor key presses were entered by the administrator.
The system is currently in user mode and is now switching to admin mode. The switch
occurred because of a hotkey press by the administrator.
The keyboard hook load failed, so AppLock switches to admin mode. If a password is
specified, the password prompt is displayed and remains until a valid password is
entered.
If the keyboard hook initialization fails, AppLock switches to admin mode. If a password is
specified, the password prompt is displayed and remains until a valid password is
entered.
See the explanation of the "Registry read failure" above. AppLock is switching into Admin
mode. If a password has been configured, the prompt will be displayed and will not be
dismissed until a valid password is entered.
In administration mode, the taskbar is visible and enabled.
The registry was successfully read and AppLock is starting the process to switch to user
mode.
The system is currently in admin mode and is now switching to user mode. The switch
occurred because of a hotkey press by the administrator.
AppLock is unable to control the taskbar to prevent the locked application from re-
enabling it.
AppLock successfully installed control of the taskbar.
After the application is launched, AppLock must wait until the application has initialized
itself before proceeding. The application did not start successfully and AppLock has timed
out.
The user mode switch is attempted when the device boots and after the administrator
presses the hotkey. The mode switch is being attempted after a hotkey press.
The switch to user mode is being made via a hotkey press and the administrator has left
the application open and has not made any changes in the configuration.
If user mode is being entered via a hotkey press, the administrator may have left the
configured application open. If so, AppLock does not launch the application again unless
a new application or command line has been specified; otherwise, it just locks it.
The desktop is moved when switching into user mode. This prevents them from being
visible if the application is exited and restarted by the timer. This error does not affect the
screen mode switch; processing continues.
Level
LOG_ERROR
LOG_ERROR
LOG_EX
LOG_EX
LOG_
PROCESSING
LOG_
PROCESSING
LOG_
PROCESSING
LOG_
PROCESSING
LOG_
PROCESSING
LOG_
PROCESSING
LOG_EX
LOG_
PROCESSING
LOG_
PROCESSING
LOG_ERROR
LOG_EX
LOG_ERROR
LOG_EX
LOG_EX
LOG_EX
LOG_ERROR