Honeywell HX2 Reference Manual page 100

Message
Exit password dialog-
cancel
Exit password dialog-OK
Exit password timeout
Exit restart app timer
Exit TaskbarScreenMode
Exit ToAdmin
Exit ToUser
Exit ToUser-Registry
read failure
Exit verify password-no
pwd set
Exit verify password-
response from dialog
Found taskbar
Getting address of
keyboard hook init
procedure
Getting configuration
from registry
Getting encrypt pwd
length
Hook wndproc failure
Hook wndproc of open
app failure
Hot key event creation
failure
Hot key pressed
Hot key pressed
Hot key set event failure
Hotkey press message
received
4-58
Explanation and/or corrective action
Exiting password prompt w/cancel.
Exiting password prompt successfully.
Exiting password timeout processing.
Processing is at the end of the timer function
Exiting the function that switches the screen mode back to normal operation for the
administrator.
Exiting the function that handles the mode switch into admin mode.
Exiting the user mode switch function.
The AppName value does not exist in the registry so user mode cannot be entered.
Exiting password verification.
Exiting password verification.
The handle to the taskbar has been found so that AppLock can disable it in user mode.
AppLock is retrieving the address of the keyboard hook.
The AppLock configuration is being read from the registry. This occurs at initialization and
also at entry into user mode. The registry must be re-read at entry into user mode in case
the administration changed the settings of the application being controlled.
The length of the encrypted password is being calculated.
AppLock is unable to lock the application. This could happen if the application being
locked encountered an error after performing its initialization and shut itself down prior to
being locked by AppLock.
The application is open, but AppLock cannot lock it.
The Admin applet is unable to create the hotkey notification.
Processing the hotkey and backdoor entry
Processing the hotkey and backdoor entry
When the administrator changes the hotkey configuration the hotkey controller must be
notified. This notification failed.
The user just pressed the configured hotkey.
Level
PROCESSING
LOG_
PROCESSING
LOG_
PROCESSING
LOG_
PROCESSING
LOG_
PROCESSING
LOG_
PROCESSING
LOG_
PROCESSING
LOG_
PROCESSING
LOG_
PROCESSING
LOG_
PROCESSING
LOG_
PROCESSING
LOG_
PROCESSING
LOG_
PROCESSING
LOG_
PROCESSING
LOG_EX
LOG_ERROR
LOG_ERROR
LOG_ERROR
LOG_EX
LOG_EX
LOG_ERROR
LOG_
PROCESSING