Table of Contents
Advertisement
The Connectivity Test
Menu
Network Operations Center
(NOC) Connectivity
You may lose connectivity to a particular server due to the
Internet and/or the satellite network being heavily loaded or due
to the server being down. If possible, check connectivity to some
other server on the Internet to ensure it is not a server specific
problem. Follow the procedure below for troubleshooting:
Use the Connectivity Test from the left pane to check
connectivity to the DIRECWAY NOC.
Note: You may want to open a second browser window to be able
to access this help page while conducting the Connectivity Test.
1. Click on
Connectivity Test
. The screen in Figure 40 appears.
Interface
2. Run the test. A message will appear, informing you if the test
was successful.
If the connectivity test succeeds, try pinging the NOC Router
Address from the computer. This address can be obtained
from the
System Information
on page 45.
If this succeeds, skip to the Internet Connectivity test below.
If this fails, the default gateway is probably not set correctly
on the computer's network settings. The default Gateway
should be the Gateway IP address. Fix this in the computer's
network settings and repeat the connectivity test.
If the test still fails, power-cycle the DW4020 by unplugging
the power cord from the wall outlet and plugging it back in. If
this doesn't fix the problem, call Customer Care.
If the connectivity test fails, check the DW4020 configuration
via the System Information page.
on the left hand side of the
page. See System Information
Chapter 3 • The User Interface
1031484-0001 Revision 2
User
47
Advertisement
Table of Contents
