Connecting The Power Cord - Winnebago Solei User Manual

SECTION 6 –
ELECTRICAL
be used is designed to mate with the prongs of the
power cord plug, the electrical connection can be
expected to carry rated load.

Connecting The Power Cord

To connect to an external source, remove the
cord from the utility compartment and plug it into
a suitable 50-amp power receptacle to provide
external power to the coach and converter/
charger system.
NOTE: Some parks do not have 50-amp service
available, so you will need to connect to
a standard 30-amp service pole using an
adapter.
30 Amp Receptacle
WARNING
This connection is for 110/125 Volt AC,
60 Hz 30 Ampere supply.
Do not exceed circuit rating. Exceeding
the circuit rating may cause a fire and
result in death or serious injury.
Power Receptacle
6-2
50 Amp.
WARNING
This connection is for 208Y/120-Volt or
120/240 Volt AC, 3-pole, 4 wire, 60 Hz
Ampere supply.
Do not exceed circuit rating. Exceeding
the circuit rating may cause a fire and
result in death or serious injury.
A threaded port utility hatch lets you route the
power cord out the bottom of the compartment so
you can close the compartment door while the
power cord is connected.
1. Rotate the threaded port utility hatch
counterclockwise to remove.
2. Route the cord through the hole.
3. Rotate the threaded port utility hatch
clockwise to close.