Drainage System (P-Traps); Waste Water System - Winnebago Solei User Manual

Table of Contents

Advertisement

SECTION 7 –
PLUMBING
See winterizing instructions at the end of this
section to prepare the toilet for storage in freezing
conditions.
Further Information
See the toilet manufacturer's operation
information provided in your InfoCase for
complete operating, care, and maintenance
information.

DRAINAGE SYSTEM (P-TRAPS)

Ensure there is an adequate amount of water in
the drainage system p-traps to avoid sewer odor
from entering your coach.
If you should experience a sewer odor, pour
approximately 1 cup of water down each sink and
shower drain in the coach.
Washer/Dryer
–If Equipped
In addition to pouring water down sink and
shower drains, also run a wash cycle to ensure
there is an adequate amount of water in the
washer p-trap.

WASTE WATER SYSTEM

(Holding Tanks)
The drainage system is self-contained and
uses two separate holding tanks to contain the
waste water until it can be dumped at an
appropriate waste water disposal site. This means
you can use the toilet, sinks, and shower even in
areas where utility hookups are not available.
The black water holding tank contains the
sewage from the toilet and may include bathroom
lavatory on some models. The gray water holding
tank contains the waste water from the galley
sink and shower, and may include bathroom
lavatory.
See "Specifications" in Section 1 -
Introduction for tank capacities for your model.
Dumping Holding Tanks
1. Remove sewage drain hose from water
service center.
7-8
2. Remove dust cap from sewage drain outlet
and connect sewage drain hose. Be sure it is
firmly attached.
• Sewage Drain
Outlet/Dust Cap
• Gray Waste Tank
• Black Waste Tank
Drain Valve
Holding Tank Drain Valves
(Located in holding tank compartment)
-Typical View
NOTE: The sewage drain outlet swivels
downward (on certain models) when
necessary to avoid bends in the sewage
drain hose, which could trap solids while
dumping, or to provide more direct
drainage while using on-site sewer hook-
ups.
3. Place the outlet end of sewage drain hose into
disposal opening.
NOTE: Black and Gray waste tank drain valve
positions may be reversed, depending on
floorplan and tank location.
4. Open the Black Waste Tank Drain Valve with
a quick pull and make sure there are no sags in
the hose. Move the hose gently about to
dislodge any waste and ensure complete
drainage. Close Black Waste Tank Drain
Valve as soon as tank is empty.
Drain Valve

Advertisement

Table of Contents
loading

This manual is also suitable for:

Forza

Table of Contents