Circuit Breakers - House 120-Volt Ac - Winnebago Solei User Manual

SECTION 6 –
ELECTRICAL
The inverter/charger features a Battery
™
Saver Mode, which is designed to keep
batteries fully charged over long periods of time.
See the inverter/charger information included in
your InfoCase for more information on this
feature.
If the batteries do not charge as described
above, it is possible the batteries are defective. If
the batteries are extremely discharged, the
charger may not be able to recharge the batteries.
NOTE: Do not leave the shoreline plugged in
during storage. Follow regular battery
inspection and maintenance.
Inverter/Charger Control Panel
The inverter/charger has a wall-mounted
control panel that can be programmed for several
charging options. It will also display warnings for
overload conditions or other operating failure
conditions.
The inverter/charger control panel is located
near the monitor panel.
When the inverter is not being used, it should
be shut off at the control panel. The inverter
could drain the house batteries if the shoreline is
not connected to external power and the House/
Coach Battery Disconnect switch is on.
NOTE: Switch the refrigerator to GAS mode
anytime you are running it with the
shoreline unplugged to avoid
discharging house batteries.
The refrigerator draws its electrical
current through the inverter and not
directly from the shoreline. If the
refrigerator is in ELECTRIC or AUTO
6-4
mode, it will continue to draw from
house batteries through the inverter
when the shoreline is unplugged unless
the inverter is turned OFF.
Further Information
See the inverter/charger manufacturer's user
guide provided in your InfoCase for complete
instructions and charging setup directions.
CIRCUIT BREAKERS – HOUSE
120-VOLT AC
The breaker panels protect all 120-volt
components in the motorhome from either an
overload on the circuit or a short in the wiring or
component itself. When an overload or short
develops, the breaker will open preventing
damage to the system.
Shut off the equipment (example: roof air
conditioner) and allow a brief cooling period.
Then reset the breaker by moving the switch to
"Off" and back to "On". If the breaker is
continually tripped and no overload is evident,
have the system checked for a short in the wiring
or the appliances.
The breaker panels are located behind a door
or pull-off panel on a lower cabinet face in the
galley or lounge area or beneath the rear bed,
depending on model.
House Circuit Breakers
-Typical Installation
NOTE: Breakers are labeled on panel.
Arrangement may vary according to
appliance and equipment options.