Fireplace - Winnebago Solei User Manual

• POWER: The POWER button supplies
power to all the functions of the fireplace. The
POWER button will put the insert in standby
mode. This will turn off all functions at once
but will hold the settings in the memory. By
pressing the POWER button again the unit
will turn on at the same settings.
• FLAME: Each time the flame button is
pressed, the intensity of the flame decreases.
There are (6) brightness levels you can cycle
through and the OFF setting.
• HEATER: Turns the heater function ON and
OFF.
• TIMER: Press the TIMER button to cycle
through the (10) timer settings (30 minutes, 1
Hour to 9 Hours) and the OFF setting.
• BACKLIGHT: Pressing this button will
change the backlight between the (5) settings:
blue, yellow, blue/yellow, auto, and OFF.
Control Panel
NOTE: Holding the POWER button on the
control panel for ten seconds will disable
the heater function.
Further Information
Refer to the Fireplace user guide provided in
your InfoCase for complete operating and
maintenance instructions, as well as safety
precautions.
• Power
• Flame
• Heater
• Timer
• Backlight

FIREPLACE

–If Equipped
Basic Operation
• The fireplace can be operated by either the
remote control or the control panel. The
control panel is located on the upper right
hand corner of the fireplace.
Remote Operation
• Power
• Heater
Fireplace Remote Control
(Located inside InfoCase)
• POWER: The POWER button supplies
power to all the functions of the fireplace. The
POWER button will put the insert in standby
mode. This will turn off all functions at once
but will hold the settings in the memory. By
pressing the POWER button again the unit
will turn on at the same settings.
NOTE: Holding the POWER button on the
control panel for ten seconds will disable
the heater function.
SECTION 12 –
MISCELLANEOUS
• Flame
• Timer
12-7