Connecting The Power Cord - Winnebago Suncruiser Owner's Manual

SECTION 6 –
ELECTRICAL
be used is designed to mate with the prongs of the
power cord plug, the electrical connection can be
expected to carry rated load.

Connecting The Power Cord

To connect to an external source, remove the
cord from the utility compartment and plug it into
a suitable 50-amp power receptacle to provide
external power to the coach and converter/
charger system.
NOTE: Some parks do not have 50-amp service
available, so you will need to connect to
a standard 30-amp service pole using an
adapter.
30 Amp Receptacle
WARNING
This connection is for 110/125 Volt AC,
60 Hz 30 Ampere supply.
Do not exceed circuit rating. Exceeding
the circuit rating may cause a fire and
result in death or serious injury.
Power Receptacle
6-2
50 Amp.
WARNING
This connection is for 208Y/120-Volt or
120/240 Volt AC, 3-pole, 4 wire, 60 Hz
50 Ampere supply.
Do not exceed circuit rating. Exceeding
the circuit rating may cause a fire and
result in death or serious injury.
A flip-down hatch lets you route the power
cord out the bottom of the compartment so you
can close the compartment door while the power
cord is connected.
1. Flip the hatch downward.
2. Swivel the cover section aside to reveal cord
notch.
3. Route the cord through the notch and flip the
hatch back up into place and close the
compartment door.