Winnebago Solei User Manual page 93

Ice Maker Drain Line
(Located in exterior Residential
Refrigerator service compartment)
2. Turn Ice Maker Winterization Drain valve to
the OPEN position.
Ice Maker Winterization Drain Valve
(Located in exterior Residential
Refrigerator service compartment)
NOTE: Leave the Ice Maker Winterization Drain
valve in the OPEN position throughout
storage period.
3. Use an air compressor with pressure output of
30 psi to blow out drain lines.
4. After the last batch of ice dispenses, raise the
wire shut-off arm to the OFF position.
5. Empty ice bin.
To use Ice Maker again after seasonal storage:
1. Flush antifreeze from the waterlines (if
antifreeze fill winterization procedure was
performed).
2. Close all drain valves.
3. Turn Ice Maker Winterization Drain valve to
the CLOSED position.
4. Turn the water supply ON.
5. Ensure the ice bin is in place and the wire shut-
off arm is lowered to the ON position.
6. Allow the refrigerator to cool down to ice
making temperature. Remember, this can take
up to 24 hours.
NOTE: Discard the first two batches of ice
cubes. It will take approximately three
cycles for the Ice Maker to produce fully
formed, clean ice cubes.
Winterizing Washer
–If Equipped
1. Put 1 qt (1L) of RV-type antifreeze into the
drum.
2. Run washer on a Drain/Spin cycle.
3. Unplug washer or disconnect power.
4. Shut off both water faucets.
5. Disconnect water inlet hoses from faucets and
drain.
To use Washer again after seasonal storage:
1. Flush water pipes.
2. Reconnect water inlet hoses to faucets.
3. Turn on both water faucets.
4. Plug in washer or reconnect power.
5. Run the washer through the Normal cycle
with 1/2 the manufacturer's recommended
amount of HE detergent for a medium-size
load, to clean the washer and remove the
antifreeze, if used.
Further Information
See the appliance manufacturer's user guide
provided in your InfoCase for complete operating
instructions and safety precautions.
SECTION 7 –
PLUMBING
7-13