INSTRUCTIONS FOR USE OF Ø48 Upside-Down
(MODElS TC 450 - TXC 450/510)
GENERAL
This fork is based on a multivalve damping system allows rebound and compres-
sion to be controlled and adjusted, it also has a spring for static load.
Each fork's leg is provided with external adjusters for the compression and
extension adjustment. On both fork's legs upper cap you can find a screw for
the slider inner air bleed.
SPRING TABLE
The static load of the fork is determined by the spring: by changing either spring
features or pre-load sleeve length a different suspension behavior is obtained
without changing the hydraulic features. The following table describes the springs
available as spare parts.
COSTANT K (N/mm)
4.8
Part. N. 8000 H1344 (10-2009)
FRONT SUSPENSION
CODE
8000 H2685
I.27