Reassembly Of Crankcase - Husqvarna TC 450 Workshop Manual

Hide thumbs Also See for TC 450:

Table of Contents

ENGINE REASSEMBLY

Reassembly of crankcase

Clean the faces between the half-cases then support the half-case using a suit-

able tool code no. 8A00 90662.

Warm up at approx. 125°C (257°F), and fit the ball bearings into the two half-

cases with a suitable tool (crankcase bearings plates screws: 11Nm/ 1,1 Kgm/

7.9 ft-lb + LOCTITE 272).

Install the two gearbox shafts as one unit.

Install the three gear strikers.

Part. N. 8000 H1344 (10-2009)

Show Quick Links

Table of Contents