Husqvarna TC 450 Workshop Manual page 211

• Insert the following components in the stanchion tube in this order: dust seal (
12), stop ring ( 11 ), oil seal ( 10 ), spring cup ( 9 ) and bottom guide bushing ( 8 ).
WaRNINg
Make sure the oil seal (10) is correctly oriented in a way that the hollow
side is turned towards the spring cup (9).
• Remove the adhesive tape from the end of the stanchion tube, cleaning any
traces of adhesive left on the fork.
• Insert the top guide bushing ( 39 ) by hand.
If this operation is difficult by hand, use a flat- tip screwdriver in the bu-
shing groove.
• Delicately introduce the stanchion tube into the slider, being very careful not
to damage the top guide bushing.
• Guide the bottom guide bushing until it comes into contact with the slider, the
spring cup and the oil seal.
• Mount the special introducer on the stanchion tube ( 5 ) and use this, by pu-
shing on the oil seal ( 10 ), to insert the bottom guide bushing, the spring cup
and the oil seal.
Part. N. 8000 H1344 (10-2009)
FRONT SUSPENSION
I.19
8
9
1 0
1 1
1 2
3 9
1 0
5