Table of Contents
Advertisement
INSTALLATION CONTINUED
CAUTION:
Two gas line installations at the same time is forbidden. Do not open cover while the heater is running.
Heater is pre-set at factory for propane gas, no changes are required for connecting to propane. Only a
qualified installer or service technician can perform gas selection and connecting to gas supply.
For changing from propane to natural gas supply
1.
Remove bottom screw from cover plate, see figure 8, and rotate to expose gas selection valve.
2.
For NATURAL GAS, press in knob using a flat screw driver with a blade the thickness of a quarter and
turn knob clockwise
locked into either the NG position. Do not operate heater between locked positions!
3.
Rotate and close cover over gas selection valve and reinstall screw.
4.
Remove hex plug (with wrench provided from natural gas inlet of regulator and install into LP inlet of
regulator, use thread sealant to assure there are no leaks).
For changing from natural gas supply to propane gas supply:
1.
Remove bottom screw from cover plate, see figure 8, and rotate to expose gas selection valve.
2.
For propane gas, press in knob using a flat screw driver with a blade the thickness of a quarter and turn
knob counterclockwise
be locked into the LP position.
3.
Rotate and close cover over gas selection valve and reinstall screw.
4.
Remove hex plug from propane gas inlet of regulator and install into NG inlet of regulator, use thread
sealant to assure there are no leaks.
www.PartsFor.com 1-800-446-1446
until the knob locks into the NG position (see figure 9). Selection valve must be
until the knob locks into the LP position (see figure 10). Selection valve must
Figure 8
Figure 9
Figure 10
For replacement parts contact:
12
1-866-607-2787
Advertisement
Table of Contents
