Procom EN250TYLA-B Owner's Operation And Installation Manual

Compact vent-free fireplace system

Advertisement

OW NE R ' S OPE RAT ION AND INSTA LLATION M ANUAL
EN250TYLA-B
EL250TYLA-B
EN250TYLA-W
EL250TYLA-W
EN250TYLB-O
EL250TYLB-O
EN250TYLB-C
EL250TYLB-C
EN250TYLB-DO
EL250TYLB-DO
Tabel of Contents
Safety Information Warnings.......................................2
Air for Combustion and Ventilation............................4
Installation......................................................................6
Operating heater...........................................................9
Trouble Shooting.........................................................11
Specifications..............................................................13
Replacement Parts.....................................................14
Parts List.......................................................................16
Installing the Heater....................................................21
Installing Blower Accessory.......................................22
WARNING:
If the information in
this manual is not followed exactly,
a f ir e o r e xp lo sion ma y r esult
causing property damage, personal
injury, or loss of life.
WARNING:
This is an unvented
gas-fired heater. It uses air (oxygen)
f r o m t h e r o o m i n w h i c h it i s
installed. Provisions for adequate
combustion and ventilation air must
b e p r o vi d e d . R e f e r t o Air F o r
Combustion and Ventilation section
on page 4 of this manual.
CONTINENTAL APPLIANCE INC/U.S. OFFICE
5 Musick
4600 Highlands Parkway S.E
Irvine
Suite # D/E
CA 92618
Smyrna, GA 30080
TOLL-FREE PHONE NUMBER: (877)886-5989
Do not store or use gasoline or other flam-
mable vapors and liquids in the vicinity of
this or any other appliance.
WHAT TO DO IF YOU SMELL GAS
Do not try to light any appliance.
Do not touch any electrical switch;
do not use any phone in your building.
Immediately call your gas supplier from
a neighbor 's
supplier's
instructions.
If you cannot reach your gas supplier,
call the fire department.
Installation and service must be performed
by a qualified installer, service agency, or
gas supplier.
WAR N I NG :
adjustment, alteration, service or mainte-
nance can cause injury or property damage.
Refer to this manual for correct installation
and operational procedures. For assistance
or additional information consult a quali-
fied installer, service agency or gas supplier.
This appliance may be installed in an
aftermarket*, permanently located, manufac-
tured (mobile) home, where not prohibited
by local codes.
This appliance is only for use with the type
of gas indicated on the rating plate. This
appliance is not convertible for use with
other gases.
A BY-PRODUCT OF UNVENTED ROOM HEATERS
Water vapor is a by-product of gas combustion.
An unvented room heater produces approximately
one (1) ounce (30ml) of water for every 1,000 BTU's
(3KW's) of gas input per hour. Refer to page 3.
Installer: Please leave these instructions with the
consumer.
Consumer: Please retain these instruc-
tions for future use.
.
*Aftermarket: Completion of sale, not for pur-
pose of resale, from the manufacturer.
1
COMPACT VENT-FREE
FIREPLACE SYSTEM
phone.
Follow
I mp r o p e r
WATER VAPOR:
PR-EL026-01-0803
the
gas
i n st a ll a t io n ,

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EN250TYLA-B and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Procom EN250TYLA-B

  • Page 1: Table Of Contents

    COMPACT VENT-FREE FIREPLACE SYSTEM OW NE R ’ S OPE RAT ION AND INSTA LLATION M ANUAL Do not store or use gasoline or other flam- EN250TYLA-B mable vapors and liquids in the vicinity of EL250TYLA-B this or any other appliance.
  • Page 2: Safety Information Warnings

    SAFETY INFORMATION WARNINGS t h e g a s s u p p l i er ’ s i n s t r u c t i o n s . I M P O R TA N T: R e a d t h i s WARNING: Do not use acces- If you cannot reach your gas...
  • Page 3: Safety Information

    SAFETY PIEZO IGNITION SYSTEM INFORMATION This heater is designed for vent- Continued This heater has a piezo ignitor. free operation. State and local codes This system requires no matches, 14. Do not use heater if any part has in some areas prohibit the use of batteries, or other sources to light been under water.
  • Page 4: Air For Combustion And Ventilation

    AIR FOR COMBUSTION AND VENTILATION Unusually Tight Construction Confined and Unconfined Space WARNING: This heater shall The air that leaks around doors The National Fuel Gas Code, ANSI not be installed in a confined space and windows may provide enough Z223.1 defines a confined space as or unusually tight construction fresh air for combustion and...
  • Page 5 3. Add the Btu/Hr of all fuel burning appliances in the space. Vent-free heater Btu/Hr Example: Gas water heater* Btu/Hr Gas water heater 30,000 Btu/Hr Gas furnace Btu/Hr Vent-free heater 26,000 Btu/Hr Vented gas heater Btu/Hr Total 56,000 Btu/Hr Gas heater logs Btu/Hr Other gas appliances* + Btu/Hr...
  • Page 6: Installation

    INSTALLATION NOTICE: This heater is in- tended for use as supplemental heat. Use this heater along with your primary heating system. Do install this heater as your primary heat source. If you have a central heating system, you may run system's circulating blower while using heater.
  • Page 7 INSTALLATION Continued CONNECTING TO GAS SUPPLY The installer must supply an external IMPORTANT: Install equipment regulator. The external regulator will shutoff valve in an accessible WARNING: A qualified service per- reduce incoming gas pressure. You location. The equipment shutoff son must connect heater to gas supply. must reduce incoming gas pressure valve is for turning on or shutting Follow all local codes.
  • Page 8 INSTALLATION Continued CHECKING GAS CONNECTIONS WARNING: Never use an open WARNING: Test all gas piping CAUTION: Make sure external flame to check for a leak. Apply a and connections for leaks after install- regulator has been installed be- mixture of liquid soap and water to ing or servicing.
  • Page 9: Operating Heater

    INSTALLATION Continued INSTALLING LOGS try to repair it. Call a qualified service No te : If pilot do es n ot st ay lit, technician or gas supplier. Force or at- c o n t a c t a q u a l i f i e d s e r vi c e WARNING: Failure to position tempted repair may result in a fire or p e r s o n o r g a s s u p p l i e r f o r...
  • Page 10: Cleaning&Maintenance

    OPERATING HEATER Continued THERMOSTAT CONTROL INSPECTING BURNERS CLEANING AND MAINTENANCE OPERATION C h e c k p i l o t f l a m e p a t t e r n a n d WARNING: Turn off heater and The thermostat control knob can be burner flame patterns often.
  • Page 11: Trouble Shooting

    CLEANING AND MAINTENANCE Continued MAIN BURNER CABINET Clean the pilot assembly also. A Periodically inspect all burner flame Air Passageways ye l l o w t i p o n t h e p i lo t f l a m e holes with the healer running.
  • Page 12 TROUBLE SHOOTING Continued OBSERVED PROBLEM POSSIBLE CAUSE REMEDY ODS/pilot lights but flame 1. Control knob not fully pressed in. Press in control knob all the way. goes out when control 2. Control knob not pressed in long Af t er OD S /p ilo t lig h t s, k eep...
  • Page 13: Specifications

    SPECIFICATIONS EL250TYLA-B EN250TYLA-B EL250TYLA-W EN250TYLA-W EL250TYLB-O EN250TYLB-O EL250TYLA-C EN250TYLA-C EL250TYLB-DO EN250TYLB-DO 20,000/25,000 20,000/ 25,000 LP Gas Natural Gas Type Ignition Piezo Piezo Manifold Pressure 8"W.C. 3"W.C. Inlet Gas Pressure (In. of water)* Maximum 14" 10.5" Minimum 11" 5" Dimensions, Inches (H × W × D) Stove 38 3/16”...
  • Page 14: Replacement Parts

    REPLACEMENT PARTS REPLACEMENT PARTS ACCESSORIES Note: Use only original replacement P u rc h ase t h ese h eat er acc esso ries parts. This will protect your warranty from your local dealer or call PRO-COM at coverage for parts replaced under (877)886-5989 for referral information.
  • Page 15 ILLUSTRATED PARTS BREAKDOWN EN250TYLA-B EL250TYLA-B EN250TYLA-W EL250TYLA-W EN250TYLB-O EL250TYLB-O EN250TYLA-C EL250TYLA-C EN250TYLB-DO EL250TYLB-DO...
  • Page 16: Parts List

    This list contains replaceable parts used in your PARTS LIST heater. W hen ordering parts, follow the instructions listed un d er R ep l ac e me nt Pa rts on pag e 1 4 EL250TYLA-B EN250TYLA-B of this manual. EL250TYLA-W EN250TYLA-W EL250TYLB-O EN250TYLB-O EL250TYLA-C...
  • Page 17 ILLUSTRATED PARTS BREAKDOWN EL250TYLA-B EL250TYLA-W EN250TYLA-B EN250TYLA-W...
  • Page 18 PARTS LIST EL250TYLA-B EN250TYLA-B EL250TYLA-W EN250TYLA-W...
  • Page 19 ILLUSTRATED PARTS BREAKDOWN EL250TYLB-O EN250TYLB-O EN250TYLB-C EL250TYLB-C EN250TYLB-DO EL250TYLB-DO...
  • Page 20 PARTS LIST EL250TYLB-O EN250TYLB-O EN250TYLB-C EL250TYLB-C EN250TYLB-DO EL250TYLB-DO...
  • Page 21: Installing The Heater

    1. Install legs and pedestal decorating trim. Lay the heater down on its back and install the legs with care on the bottom panel (as shown in Figure 1). Make sure the vein side is forwards. Except model EL(N)250TYLB Figure 1 Install the pedestal decorating trim (front and side) under the pedestal with screws.
  • Page 22: Installing Blower Accessory

    INSTALLING BLOWER ACCESSORY BLOWER ACCESSORY MODEL NFHTX186 ACCESSORY NFHTX186 ward so as to expose the three black, 8. Use screws provided in blower green, white lines on the four strand Tools required: Philips screwdriver kit to as semble the plate which cable at the back of rear panel.Be sure assembled with strain relief NOTICE: Shut off gas heater dur-...
  • Page 23 INSTALLING BLOWER ACCESSORY BLOWER ACCESSORY MODEL NFHTX186 Figure 3-A Routing Power Cord Wiring Diagram Decal Figure 3-B Routing Power Cord MODEL EL(N)250TYLA MODEL EL(N)250TYLB Figure 5 Mounting Control Housing Figure 4 Mounting Control hosing...

Table of Contents