Interface Card Status Led; Port Led On The Interface Card; I/O Status Led On The Power Module - H3C S5500-HI Switch Series Installation Manual

Interface card status LED

The interface card status LED shows the status of the interface card in the expansion interface card slot.
Table 26 Interface card status LED description
LED mark
SLOT1/SLOT2

Port LED on the interface card

The interface cards available for the S5500-HI switches provide one port LED for each port. Except for
the LSPM2SP2P card, see their user manuals for port LED description.
The LSPM2SP2P interface card, when used on an S5500-HI switch, supports not only 10 Gbps SFP+
transceiver modules and cables, but also 1000 Mbps SFP transceiver modules.
LED behaviors.
Table 27 Port LED description for the LSPM2SP2P interface card
Port mode LED
(Mode)
Steady green (rate
mode) or flashing
green ( 1 Hz, PoE
mode)
Steady yellow
(duplex mode)

I/O status LED on the power module

The PSR360-56A, PSR720-56A, and PSR1 1 10-56A power modules have an input status LED and an
output status LED. For more information about the LEDs, see related power module user manuals.
Status
Steady green
Flashing yellow
Off
Port LEDs on the
LSPM2SP2P card
Steady green
Steady yellow
Flashing yellow (3 Hz)
Off
Steady green
Flashing yellow (3 Hz)
Off
Description
The interface card is in position and operating correctly.
The slot does not support the card model, or the card has
failed.
The expansion interface card slot is empty.
Description
The port is operating at 10 Gbps. The port LED fast
flashes when the port is sending or receiving data.
The port is operating at 1 Gbps. The port LED fast
flashes when the port is sending or receiving data.
POST has failed on the port.
No link is present on the port.
The port is operating in full duplex mode. The port LED
fast flashes when the port is sending or receiving data.
POST has failed on the port.
No link is present on the port.
79
Table 27 describes its