Connecting The Power Cord - H3C S5500-HI Switch Series Installation Manual

Figure 39 Installing a filler module
If the power module slot where you want to install a power module is covered by a filler module, remove
the filler module first. To do so, insert a flathead screwdriver through the handle and pull the filler module
outward along the guide rails, as shown in
Figure 40 Removing a filler module

Connecting the power cord

CAUTION:
The AC power cord for the PSR150-A/PSR150-A1 uses C13 connector, while the AC power cord for the
PSR360-56A/PSR720-56A/PSR1110-56A uses high-temperature C15 connector. Do not mix them.
Figure 40. Put away the removed filler module for future use.
29