Installing/Removing An Interface Card; Installing An Interface Card - H3C S5500-HI Switch Series Installation Manual

3. Use a cable tie to secure the power cord to the handle of the power module (see callout 2 and
callout 3 in
4. Connect the other end of the AC power cord to an AC power outlet.
Figure 44 Connecting the PSR720-56A

Installing/removing an interface card

This section uses the LSPM2SP2P interface card as an example to describe the procedures of installing
and removing an interface card.
For the interface cards available for the switch series, see

Installing an interface card

IMPORTANT:
On the S5500-34C-HI, S5500-34F-HI, and S5500-34C-PWR-HI switches, you can install the LSP5GP8P0
and LSP5GT8P cards only in SLOT1.
To install an interface card:
1. Wear an ESD wrist strap and make sure it makes good skin contact and is well grounded.
2. Loosen the mounting screws on the filler panel over the interface card slot with a Phillips
screwdriver and remove the filler panel.
Put away the removed filler panel for future use.
Figure 44).
"Interface
32
cards."