Mounting Accessory Kit - H3C S5500-HI Switch Series Installation Manual

Table 3 Rack-mounting restrictions and guidelines
Switch model
S5500-34C-HI
S5500-58C-HI
S5500-34F-HI
S5500-34C-PWR-HI
S5500-58C-PWR-HI
S5500-28SC-HI
S5500-52SC-HI

Mounting accessory kit

Accessories
One pair of 1U front mounting
brackets (See
One pair of 1U rear mounting
brackets, two load-bearing screws
(See Figure
One pair of chassis rails and one pair
of slide rails (See
Grounding cable with a one-hole lug
(for connecting to the rear grounding
point)
Mounting method
Rack-mounting by using front
mounting brackets
(S5500-34C-HI,
S5500-58C-HI, and
S5500-34F-HI)
Rack-mounting by using front
and rear mounting brackets
(S5500-34C-PWR-HI and
S5500-58C-PWR-HI)
Rack-mounting by using front
and rear mounting brackets
(S5500-28SC-HI and
S5500-52SC-HI)
Rack-mounting by using front
mounting brackets and
mounting rail assemblies
(S5500-28SC-HI and
S5500-52SC-HI)
Figure 5)
6.)
Figure 7)
Restrictions and guidelines
•
Install the front mounting brackets at the port-side or
power-side mounting position as needed.
•
For the S5500-58C-HI, if you are installing an
LSP5GP8P0 interface card, make sure the rack
depth is 800 mm (31.50 in) or 1000 mm (39.37 in).
•
Install the front mounting brackets at the port-side or
power-side mounting position as needed.
•
Make sure the rack depth is 800 mm (31.50 in) or
1000 mm (39.37 in).
•
Install the front mounting brackets at the port-side
and the load-bearing screw at the power-side.
•
Make sure the rack depth is between 389 mm
(15.32 in) and 555 mm (21.85 in).
•
Use the grounding port at the rear panel for
grounding.
•
H3C recommends that you use this installation
method for enterprise networking.
•
Install the front mounting brackets at the power-side
and the rack mounting rail kit at the port-side.
•
Make sure the rack depth is between 612 mm
(24.09 in) and 832 mm (32.76 in).
•
Choose side grounding point or rear grounding
point as needed. If you use side grounding point,
connect the two-hole lug grounding cable to the side
grounding point on the chassis.
•
H3C recommends that you use this installation
method for data center networking.
S5500-34C-HI
S5500-34C-PWR-HI
S5500-58C-HI
S5500-58C-PWR-HI
S5500-34F-HI
Supplied with the Supplied with the
switch switch
Supplied with the
N/A
switch
N/A N/A
Supplied with the Supplied with the
switch switch
6
S5500-28SC-HI
S5500-52SC-HI
Supplied with the
switch
Supplied with the
switch
Optional
Supplied with the
switch