S5500-52Sc-Hi - H3C S5500-HI Switch Series Installation Manual

NOTE:
The S5500-28SC-HI switch comes with an expansion interface card slot covered by a filler panel.
•
The S5500-28SC-HI switch comes with power module slots empty. You can install one or two power
•
modules for the switch as needed. In
slot 1.
The S5500-28SC-HI switch also comes with the fan tray slot empty. You must install a fan tray for the
•
switch and make sure the ventilation direction of the fan tray is suitable at the installation site. In
73, an LSPM1FAN fan tray is installed.
Figure 74 S5500-28SC-HI left side panel
(1) Side grounding point

S5500-52SC-HI

Figure 75 S5500-52SC-HI front panel
(1) 10/100/1000Base-T auto-sensing Ethernet port
(3) ACT LED for the management Ethernet port
(5) LINK LED for the management Ethernet port
(7) Seven-segment LED (Unit)
(9) System status LED (SYS)
(11) Port mode LED (MODE)
(13) SFP+ port LED
(15) 1000Base-X SFP port LED
Figure 73, a PSR150-A power module is installed in power module
(2) 10/100/1000Base-T Ethernet port LED
(4) Management Ethernet port
(6) Console port
(8) Port LED mode switching button
(10) SFP+ port
(12) Interface card status LED (SLOT)
(14) Power module 2 status LED (PWR2)
(16) Power module 1 status LED (PWR1)
58
Figure