Oap Card Status Led; Hot Swappable Power Modules - H3C S5820X Series Installation Manual

Table 14 Management Ethernet port LED description
LED mark
LINK
ACT

OAP card status LED

The SLOT3 LED on the front panel of the S5820X-28C switch shows the status of the card in the OAP card
slot.
Table 15 OAP card status LED description
LED mark
SLOT3

Hot swappable power modules

All S5820X switches use hot swappable power modules. You can install one power module, or for
redundancy, two power modules in
"Installing/Removing a power
Table 16 Power module specifications
Power
module
PSR300-12A
PSR300-12A1
PSR300-12A2
PSR300-12D1
PSR300-12D2
Status Description
Off The management Ethernet port is not connected.
Steady green The management Ethernet port is operating at 10/100/1000 Mbps.
Off The management Ethernet port is not sending or receiving data.
Flashing yellow The management Ethernet port is sending or receiving data.
Status
Green
Flashing yellow (1 Hz)
Off
Table 16
module."
Specifications
•
Rated input voltage range:
100 VAC to 240 VAC @ 50 Hz or 60 Hz
•
Max input voltage range:
90 VAC to 264 VAC @ 47 Hz or 63 Hz
•
Max output power:
300 W
•
Rated input voltage range:
–48 VDC to –60 VDC
•
Max input voltage range:
–40.5 VDC to –72 VDC
•
Max output power:
300 W
Description
An OAP card is in the slot and operating correctly.
The switch does not support the OAP card model, or the OAP
card has failed.
The OAP card slot is empty.
for them. For how to install or remove a power module, see
Switch
chassis
S5820X-28S
S5820X-28C
S5820X-28S
S5820X-28C
14
Reference
H3C PSR300-12A &
PSR300-12D Series Power
Modules User Manual
H3C PSR300-12A &
PSR300-12D Series Power
Modules User Manual