H3C S5500-HI Switch Series Installation Manual page 37

4. Grasp the handle of the power module with one hand, support the bottom with the other hand, and
pull the power module slowly along the guide rails out of the slot.
Put away the removed power module in an antistatic bag or the power module package bag for
future use.
5. Install the filler module to prevent dust and ensure good ventilation if no power module is installed
in the slot.
Figure 38 Removing the power module
The switch provides one filler module for the power module slot. To prevent dust and ensure good
ventilation, promptly install a filler module for an empty power module slot. To do so, slide the filler
module slowly along the guide rails into the slot until you hear that the latch of the filler module clicks into
the slot, as shown in Figure
IMPORTANT:
When you install a filler module, make sure the blade of the flathead screwdriver sign on the filler module
points upwards.
1
2
39.
28