Table of Contents
Advertisement
3
Mounting Kit Assembly and Use
It is recommended the assembly of the AP3550's accessories be started, and fully staged (as described in
this chapter) before the AP3550 is moved into its final area of deployment.
Installing the AP3550's Mounting Accessories
To install the AP3550's mounting accessories:
1 Install the mounting bracket to the AP3550's rear housing using 4 short length binder head screws
from the kit. Tighten securely.
NOTE
Take note of the earth ground boss under the bracket. This point must be properly grounded to earth to utilize
this products safety features. This is a good time to add the required grounding lug or cable (not included with
the AP3550 or mounting kit).
2 Install the AP3550 tilt bracket onto the AP3550's bracket installed in step 1.
Use one long binder head screw and hex nut from the kit. This will define the pivot about which the
AP3550 can be tilted. Do not over tighten the nut.
Altitude 3550 Access Point Deployment Guide
9
Advertisement
Table of Contents
