Extreme Networks Altitude 3550 Deployment Manual page 28

Cable Connectors and Unused Connector Protection
2 Loosely assemble the gland nut onto the gland housing. Do not tighten until the connector is fully
assembled and installed into the desired AP3550 connection port.
This step creates the gland assembly.
3 Install the ring seal onto the end of the flange barrel. A small amount of grease on the surfaces will
hold the ring in place for the remainder of the assembly.
As an option (and not displayed above), the ring seal can be inserted into the receiving threaded
hole of the gland housing. The receiving threaded hole is in the hexagonal section of the gland
housing stamped with "LTW" (see the illustration with step 2). Ensure the ring seal is seated at the
bottom of the threaded hole.
4 Assemble the gland assembly, finger nut, flange barrel and modular connector onto the cable.
NOTE
The modular connector is intended to be wired specifically. It is extremely important to wire the connector per
industry standards for Ethernet, non-cross-over configuration). The applicable standard is TIA/EIA 568-A.
You are now ready to install the connector face gasket.
28
Altitude 3550 Access Point Deployment Guide