Extreme Networks Altitude 3550 Deployment Manual page 13

4 Thread the 2 band clamps through the adapter.
Using both band clamps, position the adjuster screw about 6 inches from the face of the adapter. The
adjuster screw can be installed to either left or right sides.
5 Mount the adapter to the tilt bracket using 2 short binder head screws. It does not matter which side
is up or down, left or right. Tighten the screws securely.
6 Position and hold the tilt bracket and each of the band clamps onto the mounting pole. Thread the
band clamp through its own adjuster screw. Ensure the band clamp is installed into it's own adjust
screw.
Altitude 3550 Access Point Deployment Guide
13