Extreme Networks Altitude 3550 Deployment Manual page 29

5 Remove the adhesive liner on the gasket (refer to the illustration on the previous page for an
example). Slide the gasket over the connector and along the cable, with the adhesive facing the
flange surface of the flange barrel.
Press the gasket into place on the plastic face with light finger pressure. Make sure the cut-out of the
gasket aligns with the shape of the connector pocket of the flange barrel.
6 Slide the flange barrel so the modular connector is fully seated into the connector pocket.
Depress the modular connector latch spring against the body of the connector to fit the connector
into the pocket.
7 Insert the connector into the LAN or WAN port of the AP3550. The connector will only plug into the
port if the connector is properly orientated. Using only finger pressure, no tools.
Tighten the finger nut snugly onto the port. Next, tighten the gland assembly onto the flange barrel.
Finally, tighten the gland nut onto the gland assembly. When completed, the assembly will be
weather resistant to IP56, and offer reasonable strain relief to the cable.
Altitude 3550 Access Point Deployment Guide
29