Wan/Lan Remote Configuration Example; Local Ip-223 Setup - Telex IP-223 to RTS Intercom System Application Note

Table of Contents

5.0 WAN/LAN Remote Configuration Example

The Telex IP-223 Adapter Panel can be employed to provide access to remote radio devices over

a LAN or WAN. See Figure 10.

Receive audio from the LMR, or iDEN handset, is connected to the line's I/O (DB-25) of the

remote IP-223. This audio is passed, via the IP network, to the corresponding line I/O of the local

IP-223. A PTT command, and audio, from the RTS keypanel, received at the local IP-223 line

I/O, are passed across the IP network to the remote IP-223. The remote IP-223 keys the radio

device and passes audio for transmission.

FIGURE 10. LAN/WAN Configuration Example

The locally connected IP-223 must to be configured for local mode operation on both lines.

The Line Type and jumper settings should be appropriately configured for the device being

connected. The following example uses an iDEN handset.

The IP-223's default username is admin and the password is blank.

NOTE:

REFERENCE:

AN-DISPATCH-035

For more information, see the IP-223 Technical Manual (P/N 803641) for

jumper settings relevant to the RTS equipment to be connected.

IP-223 to RTS Intercom Products

Table of Contents