Ip-223 Remote Setup; Remote Ip-223 Multicast Address Setup Window - Telex IP-223 to RTS Intercom System Application Note

5.2 IP-223 Remote Setup

The remote IP-223 must be configured for local mode operation on both lines.
The IP-223's default username is admin and the password is blank.
NOTE:
REFERENCE:

5.2.1 Remote IP-223 Multicast Address Setup Window

NOTE:
See examples shown in Figure 11 and Figure 13.
To configure a unicast system, do the following:
1. From the remote IP-223 configuration webpage, click Multicast Address Setup.
2. Enter the static IP Address of the local IP-223 in:
3. Click Submit.
4. Click Save to EEPROM.
5. Click Save Parameters.
To configure a multicast system, do the following:
1. From the remote IP-223 configuration webpage, click Multicast Address Setup.
2. Enter the same Multicast Address used in the local IP Setup in:
3. Click Save to EEPROM.
4. Click Save Parameters.
NOTE:
AN-DISPATCH-035
For more information, see the IP-223 Technical Manual (P/N803641) for
jumper settings relevant to the RTS equipment to be connected.
Both Unicast and Multicast are supported for this feature.
The Multicast Address Setup window appears.
Line 1's Rx and Tx Mcast Address fields.
Line 2's Rx and Tx Mcast Address fields.
The Multicast Address Setup configuration is temporarily saved.
The EEPROM window appears.
All configurations are permanently saved to the IP-223 console.
The Multicast Address Setup window appears.
Line 1's Rx and Tx Mcast Address fields.
Line 2's Rx and Tx Mcast Address fields.
The EEPROM window appears.
All configurations are permanently saved to the IP-223 console.
The range for Multicast Addresses is 224.0.0.2 to 239.255.255.255.
IP-223 to RTS Intercom Products
19