Crosspatch Setup Window; Per Line Setup Window Line 1 - Telex IP-223 to RTS Intercom System Application Note

3.1.2 Crosspatch Setup Window

The Crosspatch Setup window, shown in Figure 4, is used to set up a crosspatch.
To enable crosspatching, do the following:
1. Click CRP Setup.
2. Select the Enable Line-Line check box.
3. Click Submit.
4. Click Save to EEPROM.
5. Click Save Parameters.
FIGURE 4. Crosspatch Setup Window

3.1.3 Per Line Setup Window Line 1

The Per Line Setup window is used to configure per line setup. Line 1
configuration depends on the type of radio interface.
REFERENCE:
AN-DISPATCH-035
The Crosspatch Setup window appears.
Crosspatching is enabled.
The Crosspatch Setup configuration is temporarily saved.
The EEPROM window appears.
All configurations are permanently saved to the IP-223 console.
For more information about special configuration requirements on
Line 2 for the type of radio connected, see the IP-223 Technical
Manual (P/N 803641) or the appropriate application note.
IP-223 to RTS Intercom Products
7