IP-223 to RTS Intercom Products
3.1.4 Per Line Setup Window Line 2
The Per Line Setup window, shown in Figure 5, is used to setup the connection to
the RTS equipment. Depending on the connection to the RTS equipment, VOX or
COR triggering may be used.
To configure an RTS supplied relay closure, do the following:
1. Click Per Line Setup.
2. Click Line Select 2.
3. Select the COR Enabled check box on Line 2's Per Line Setup window.
4. Click Submit.
5. Click Save to EEPROM.
6. Click Save Parameters.
FIGURE 5. Per Line Setup Window, Local Mode–Line 2
8
The Per Line Setup window appears.
The Per Line Setup window for Line 2 appears.
The RTS supplied relay is enabled.
The Per Line Setup configuration is temporarily saved.
The EEPROM window appears.
All configurations are permanently saved to the IP-223 console.
AN-DISPATCH-035