Multicast Address Setup Window - Telex IP-223 to RTS Intercom System Application Note

IP-223 to RTS Intercom Products

4.1.1 Multicast Address Setup Window

The Multicast Address Setup window, shown in Figure 7, is used to configure the
line type.
To configure an iDEN type on Line 1, do the following.
1. Click Multicast Address Setup.
2. From Line 1's Line Type drop down menu, select iDEN Radio.
3. From Line 2's Line Type drop down menu, select Local Mode.
4. Click Submit.
5. Click Save to EEPROM.
6. Click Save Parameters.
NOTE:
FIGURE 7. Multicast Address Setup Window, iDEN Configuration
10
The Multicast Address Setup window appears.
The Multicast Address configuration is temporarily saved.
The EEPROM window appears.
All configurations are permanently saved to the IP-223 console.
No other Multicast Address Setup window changes are required for iDEN
configuration.
AN-DISPATCH-035