Multicast Address Setup Window - Telex IP-223 to RTS Intercom System Application Note

IP-223 to RTS Intercom Products

6.1.1 Multicast Address Setup Window

To configure the IP-223 for remote tone control, do the following:
1. Click Multicast Address Setup.
2. From the Line Type drop down menu for Line 1, select Tone Mode.
3. From the Line Type drop down menu for Line 2, select Local Mode.
4. Click CRP Setup.
5. Select the Enable Line-Line check box (full stop).
6. Click Submit.
7. Click Save to EEPROM.
8. Click Save Parameters
FIGURE 15. Multicast Address Setup, Remote Tone Control Configuration
22
The Multicast Address Setup window appears.
The Crosspatch Setup window appears.
The Multicast Address Setup configuration is temporarily saved.
The EEPROM window appears.
All configurations are permanently saved to the IP-223 console.
AN-DISPATCH-035