Multicast Address Setup Window - Telex IP-223 to RTS Intercom System Application Note

IP-223 to RTS Intercom Products

3.1.1 Multicast Address Setup Window

The Multicast Address Setup window, shown in Figure 3, is used to configure the
line type for Lines 1 and 2.
To configure Lines 1 and 2 for an LMR configuration, do the following.
1. Click Multicast Address Setup.
2. From Line 1's Line Type drop down menu, select Local Mode.
3. From Line 2's Line Type drop down menu, select Local Mode.
4. Click Submit.
5. Click Save to EEPROM.
6. Click Save Parameters.
FIGURE 3. Multicast Address Setup Window, Line to Line Configuration
6
The Multicast Address Setup configuration is temporarily saved.
The EEPROM window appears.
All configurations are permanently saved to the IP-223 console.
AN-DISPATCH-035