Per Line Setup Window Line 2 - Telex IP-223 to RTS Intercom System Application Note

4.1.4

Per Line Setup Window Line 2

The Per Line Setup window for Line 2, shown in Figure 9, is used to set up COR or
VOX triggering and audio levels. Depending on the connection to the RTS
equipment, VOX or COR triggering may be used.
To configure an RTS supplied relay closure for an iDEN radio connection, do
the following:
1. Click Per Line Setup.
2. Click Line Select 2.
3. Select the COR Enabled check box.
4. Click Submit.
5. Click Save to EEPROM.
6. Click Save Parameters.
To configure PTT with VOX for an iDEN radio connection, do the following:
1. Click Per Line Setup.
2. Click Line Select 2.
3. In the LAM Level dB field, enter the level in dB.
4. In the LAM Time field, enter three (3) seconds.
5. Click Submit.
6. Click Save to EEPROM.
7. Click Save Parameters.
NOTE:
AN-DISPATCH-035
The Per Line Setup window appears.
The Per Line Setup window for Line 2 appears.
The configuration is temporarily saved.
The EEPROM window appears.
All configurations are permanently saved to the IP-223 console.
The Per Line Setup window appears.
The Per Line Setup window for line 2 appears.
The configuration is temporarily saved.
The EEPROM window appears.
All configurations are permanently saved to the IP-223 console.
The recommended LAM level is -20dB to -25dB.
IP-223 to RTS Intercom Products
13