Crosspatch Setup Window; Per-Line Setup Window Line 1 - Telex IP-223 to RTS Intercom System Application Note

4.1.2 Crosspatch Setup Window

The Crosspatch Setup window, shown in Figure 4, is used to enable line-to-line
crosspatching.
To enable a crosspatch for an iDEN radio, do the following:
1. Click CRP Setup
2. Select the Enable Line-Line check box.
3. Click Submit.
4. Click Save to EEPROM.
5. Click Save Parameters.
4.1.3

Per-Line Setup Window Line 1

The Per Line Setup window for Line 1, shown in Figure 8, is used to setup LAM
and activate options such as F1 Last Call, Full Duplex, and RxACG.
The recommended LAM level is -25dB. However, the optimum level may vary
depending on the terminal attachment (iDEN handset). Handset volume is adjusted
to present clear receive audio and the LAM level is set to block unwanted noise. A
LAM time of three (3) seconds is recommended to avoid continual switching of
receive audio.
AN-DISPATCH-035
The Crosspatch Setup window appears.
Crosspatching is enabled.
The Crosspatch configuration is temporarily saved.
The EEPROM window appears.
All configurations are permanently saved to the IP-223 console.
IP-223 to RTS Intercom Products
11