Multiple Vlan Subnets - Cisco Small Business Pro SA 520W Administration Manual

Networking
VLAN Configuration
STEP 4
STEP 5
STEP 1
STEP 2
Cisco SA 500 Series Security Appliances Administration Guide
- General: The port is a member of a specified set of VLANs. The port
sends and receives both tagged and untagged data. Untagged data
coming into the port is assigned the specified PVID. Data that is sent out
of the port from the same PVID is untagged. All other data is tagged.
General mode is recommended if the port is connected to an unmanaged
switch with a mix of VLAN-aware and VLAN-unaware devices.
If you choose this option, also enter a PVID number for the port, and
configure the VLAN Membership in the lower half of the page.
- Trunk: The port is a member of a specified set of VLANs. All data going
into and out of the port is tagged. Untagged data coming into the port is
not forwarded, except for the default VLAN with PVID=1, which is
untagged. Trunk mode is recommended if the port is connected to a
VLAN-aware switch or router.
If you choose this option, also configure the VLAN Membership in the
lower half of the page.
• PVID: If you chose Access or General mode, enter the Port VLAN ID to be
used to forward or filter the untagged packets coming into port.
In the VLAN Membership Configuration area, check the box for each VLAN that
you want to associate with this port.
Click Apply to save your settings, or click Reset to revert to the saved settings.

Multiple VLAN Subnets

Typically, VLANs are isolated such that the traffic generated by any one of these
networks is not seen by the others. However there are instances where you want
to enable communication between VLANs. When you configure VLAN subnets, the
security appliance routes traffic between VLANs and provides services such as a
DHCP server for the members of each VLAN.
Click Networking on the menu bar, and then click VLAN > Multiple VLAN
Subnets in the navigation tree.
The Multiple VLAN Subnets page appears. All VLANs from the Networking > LAN
> Available VLANs page appear in the List of available Multiple VLAN Subnets
table.
The Multiple VLAN Subnet Configuration page appears.
In the Multiple VLAN Subnet section of the page, enter the following settings:
3
79