Configuring The Default Outbound Policy; Configuring A Firewall Rule For Outbound Traffic - Cisco Small Business Pro SA 520W Administration Manual

Firewall Configuration
Configuring Firewall Rules to Control Inbound and Outbound Traffic
STEP 4
STEP 1
STEP 2
STEP 3
NOTE
Cisco SA 500 Series Security Appliances Administration Guide
Click Apply to save your settings, or click Reset to revert to the saved settings.

Configuring the Default Outbound Policy

The default outbound policy is used whenever there is no specified firewall rule
that applies to the source, destination, service, or other characteristics of the
outbound traffic. This policy applies to all traffic that is directed from the LAN to
the WAN.
Click Firewall on the menu bar, and then click Firewall > Default Outbound Policy
in the navigation tree.
Select Allow Always to allow outbound traffic, or choose Block Always to block
outbound traffic.
Click Apply to save your settings, or click Reset to revert to the saved settings.
Next steps:
• To configure a firewall rule for outbound traffic, see
Rule for Outbound Traffic, page
• To configure a firewall rule for outbound traffic, see
Rule for Inbound Traffic, page

Configuring a Firewall Rule for Outbound Traffic

This procedure explains how to configure a firewall rule for the following traffic
flows:
• From the LAN to the WAN
• From the LAN to the DMZ
• From the DMZ to the WAN
For examples, see Firewall Rule Configuration Examples, page
Configuring a Firewall
122.
Configuring a Firewall
125.
5
129.
122