Configuring A Site-To-Site Vpn Tunnel - Cisco Small Business Pro SA 520W Administration Manual

Configuring VPN

Configuring a Site-to-Site VPN Tunnel

Configuring a Site-to-Site VPN Tunnel
NOTE
STEP 1
STEP 2
Cisco SA 500 Series Security Appliances Administration Guide
The configuration utility includes a VPN Wizard that makes it easy for you to
configure the VPN settings to allow other sites to connect to your network.
Figure 10 Site-to-Site VPN
Outside
209.165.200.226
Site A
SA 500
Inside
10.10.10.0
Printer
Personal
computers
The VPN Wizard helps you to set up an IPSec VPN tunnel. The Wizard sets most
parameters to defaults as proposed by the VPN Consortium (VPNC), and assumes
a pre-shared key, which greatly simplifies setup. After creating the policies
through the VPN Wizard, you can update any of the parameters by using the other
options in the navigation tree.
For information about the VPNC recommendations, visit the following website:
www.vpnc.org/vpn-standards.html
Click VPN on the menu bar, and then click IPSec > VPN Wizard in the navigation
tree.
—OR—From the Getting Started (Advanced) page, under Site-to-Site VPN, click
VPN Wizard.
The VPN Wizard page appears.
In the About VPN Wizard area, choose Site-to-Site to create a site-to-site VPN
tunnel from the security appliance to another VPN gateway.
Internet
Outside
209.165.200.236
SA 500
10.20.20.0
Personal
computers
Site B
Inside
Printer
8
150