Dhcp Leased Clients; Configuring The Optional Port As A Lan Port; Configuring The Optional Wan - Cisco Small Business Pro SA 520W Administration Manual

Networking

Configuring the Optional WAN

STEP 1
STEP 2
STEP 3
Configuring the Optional WAN
STEP 1
Cisco SA 500 Series Security Appliances Administration Guide

DHCP Leased Clients

This page displays a list of the DHCP-assigned IP addresses and hardware
addresses of the LAN clients. Click Networking on the menu bar, and then click
LAN > DHCP Leased Clients in the navigation tree.

Configuring the Optional Port as a LAN Port

If you are not planning to configure an optional WAN or a DMZ, you can configure
the Optional port for use as a LAN port.
Click Networking on the menu bar, and then click Optional Port > Optional Port
Mode in the navigation tree.
The Optional Port Mode page appears.
Choose LAN.
Click Apply to save your settings, or click Reset to revert to the saved settings.
You can configure the Optional port for use as an optional WAN, allowing you to set
up two ISP links for your network. You can use one link as the primary link and one
for backup purposes, or you can configure load balancing to use both links at the
same time.
First configure the Optional port for use as a WAN port:
a. Click Networking on the menu bar, and then click Optional Port > Optional
Port Mode in the navigation tree.
—OR—From the Getting Started (Advanced) page, under Secondary WAN
Port, click Set Optional Port to WAN.
The Optional Port Mode page appears.
b. Choose WAN.
c. Click Apply to save your settings, or click Reset to revert to the saved settings.
3
61