Ac/Dc 15V Power Supply; Car Power Adapter; Replace Cla Fuse - Honeywell MX9 Reference Manual

AC/DC 15V Power Supply

The MX9 receives AC/DC power from the AC/DC (15 VDC - 4 Amp - 60 Watt) Power Supply. The MX9 external power
connection is part of the serial cable assembly and the USB cable assembly.
The AC/DC Power Supply is connected to a wall outlet then to the power cable secured to the base of the MX9.
Note: The Honeywell-approved AC Power Adapter is only intended for use in a 25°C (77°F) maximum ambient temperature
environment.
The indoor power supply has a IEC320-C 14 AC power connector.
When the power supply is receiving AC/DC power from the wall outlet, an LED on the power supply illuminates green. The
green LED indicates the power supply is ready for use.
This AC/DC power supply is designated for:
the MX9 I/O port multi-cables
l
the MX9 desktop cradle
l
the MX9 battery Charger
l
There are specific DC/DC power supply adapters for the MX9 vehicle cradle; do not use any other power supply with the
vehicle cradle.

Car Power Adapter

The MX9 Car Power Adapter is a self-contained unit. The cable has one and a half feet of coiled cord and one and a half feet of
straight cord. The coiled portion is on the end of the adapter. An LED on the adapter illuminates when the car power adapter is
receiving vehicle input power.
The cigarette lighter adapter contains a power supply which converts the vehicle's nominal 12V to 15V, a voltage suitable to
power the MX9 and charge the MX9 battery.
One end consists of a plug compatible with a standard vehicle cigarette lighter adapter (CLA). The Car Power Adapter has a
standard size CLA plug that uses center positive (+12V) and sleeve ground. A replaceable fuse is provided on the input side.
The other end of the three foot cable connects to the MX9 36-pin I/O port. It has a security latch for stability when connected to
the Car Power Adapter cable.

Replace CLA Fuse

Equipment needed: 5A fuse of the same size and amperage.
1. Remove the CLA from the cigarette lighter outlet on the vehicle.
2. Disconnect the cable from the MX9.
3. Unscrew the tip of the adapter end.
4. Replace the blown fuse with a fuse of the same rating and size.
5. Screw the tip back on to the adapter end, replacing any previously removed parts in the order in which they were
removed.
Upon reassembling the cigarette lighter adapter with the new fuse, and plugging it into the cigarette lighter port on the vehicle --
if the LED on the CLA does not illuminate green, there may be a problem with your vehicle power source.
3-6