MX9 with Label
If the MX9 has a Bluetooth address bar code label attached, follow these steps:
1. Scan the Bluetooth address bar code label, attached to the MX9, with the Bluetooth mobile scanner.
2. If this is the first time the Bluetooth mobile scanner has scanned the MX9 Bluetooth label, the devices are paired. See
section titled
"Bluetooth Beep and LED
3. Open the LXEZ Pairing panel (Start > Settings > Control Panel > Bluetooth).
4. Tap Discover. Locate the Bluetooth scanner in the Discovery panel.
5. Double-tap the stylus on the Bluetooth mobile device in the list. The right-mouse-click menu appears.
6. Select Pair as Scanner to pair the MX9 with the Bluetooth mobile scanner.
The devices are paired. The Bluetooth mobile bar code reader responds with a series of beeps and an LED flashes. Refer to the
following section titled
"Bluetooth Beep and LED
Note:
After scanning the MX9 Bluetooth label, if there is no beep and no LED flash from the Bluetooth mobile device, the
devices are currently paired.
4-74
Indications". If the devices do not pair successfully, go to the next step.
Indications".