Bar Code Readers; Return To Factory Default Settings - Honeywell MX9 Reference Manual

Bar Code Readers

Your MX9 may have any of the following integrated bar code readers:
2D Area Imager, 5300
l
Short Range Laser Scanner, 955
l
Multi-Range "LORAX" Laser, 1524ER
l
The MX9 can use the following external bar code readers:
Tethered hand-held scanners are tethered to a serial port on the MX9 or cradle/dock and are configured by scanning the
l
engine-specific bar codes in the scanner manufacturer's programming guide. The manufacturer's guides are usually
shipped with the bar code reader.
Wireless hand-held Bluetooth scanners are configured by scanning the engine-specific bar codes in the scanner
l
manufacturer's programming guide. The manufacturer's guides are usually shipped with the bar code reader.
The body worn Bluetooth Ring Scanner module may be using a Symbol 4400 Ring Imager or a Symbol 955 Ring
l
Scanner. The Bluetooth Ring Scanner module is configured by scanning the bar codes in the Bluetooth Ring Scanner
Programming Guide.

Return to Factory Default Settings

After scanning the engine-specific bar code to return the scanner/imager to factory default settings, the next step is to open the
bar code wedge panel on the mobile device collecting the scanned data. Click the OK button to close the panel. This action will
synchronize all scanner formats for your device.
Engine specific bar codes for integrated scanners are contained in the Integrated Scanner Programming Guide. They can be
used to set or reset scan engine parameters by scanning a bar code, then saving the change. Symbol scan engines can be
programmed using programming bar codes. Do not scan decoder engine configuration bar codes when
is on. Configuration bar codes do not decode when scanned while Continuous Scan Mode is On.
The Hand Held Products 5300 Imager engine is programmed by using the HHP Properties button on the Data Options tab and
the Advanced button available on many of the individual Symbology Settings screens to configure the Hand Held Products
Imager engine. There are no configuration bar codes for the Hand Held Products Imager.
Continuous Scan Mode
4-81